.. _aibs_system_config:

Configuring the AIBS Parameters Through Karabo
==============================================

To reach the configuration interface, followin the instructions for opening
the status scene (:ref:`aibs_system_status`), and click on the
`Expert View` link in that scene.


A scene very similar to the status scene will show, but importantly it
will allow you to alter certain parameters.

.. image:: media/AIBS_scene_expert.png

To change any of `Sensor Interval`,
`Sensor Window` or `Window`, type the new value and hit enter. Values might
be allowed within certain ranges only and if the value will be rejected
if out of range.

The ranges are as follows:

:Sensor Interval: 5 minutes to 1440 minutes (1 day)
:Sensor Window: 5 minutes to 40 minutes
:Window: 100 to 3500 ms.


Expert Actions
--------------

The expert scene allows for certain "Expert" actions:

.. image:: media/AIBS_scene_expert_actions.png

:Reboot AIBS: Reboots the AIBS hardware. The Karabo device will go into
    the `INIT` state until a connection to the AIBS is reestablished.

:Activate Interlocks: Active all interlocks onto the MPS relevant for this
    AIBS. The AIBS should report the `ACTIVE` state if it was previously in
    `INTERLOCK_BROKEN` or will report any other state that the hardware and
    PLC is in, e.g. `ACQUIRING` or `IDLE` in case of a reboot.

:Deactivate Interlocks: Deactivate all interlocks onto the MPS relevant for
    this AIBS. The AIBS will report the `INTERLOCK_BROKEN` state.

:Enable/Disable External Write: This is needed for firmware updates and should
    be done in consultation with EEE / D3 experts.