Welcome to Jungfrau documentation’s documentation!

Contents:

• General Introduction
  • JUNGFRAU basics
    • The ASIC
    • The readout board
    • External and internal triggering
    • Cooling
  • Dynamic Gain Switching and Raw output
    • Dynamic Gain Switching
    • Raw data output
• Network setup
  • Basic components
  • Device configuration
  • Software and firmware compatibility
• Operation
  • Turning on and off
    • Cooling
    • Power
  • Control configuration
    • Basic operation settings: CONTROL device
    • Basic operation settings: RECEIVER device
    • External trigger and autotrigger
    • Single cell and ‘Burst’ operation modes
    • Temperature Control
• Data Correction
  • Dark runs acquisition
    • JungfrauDarkChar middlelayer
    • Single cell operation
    • Burst mode operation
    • Remarks
  • Offsets injection
  • Gain correction
• Troubleshooting
  • How to use Command Line Interface
  • How to update firmware and server
    • Older client versions or incompatible SW and FW versions
  • Emergency shutdown
  • Raw preview
    • No image on the preview and the RECEIVERS are not updating
    • I can see the RECEIVERS updating but no image on the preview
    • There are striped artifacts in the image
    • Large parts of the detector have a baseline too high
  • Control and operation
    • My CONTROL or RECEIVER device is in ERROR
    • External trigger acquisition does not work